Kraun KW.04 Instrukcja Użytkownika Pobierz pdf (Strona 9)

Manual

www.kraun.com

2.3. Wireless connection (for IP Cam(w))

The IP CAM can also be connected to the home/oce network through the 802.11 b/g wireless connection.

There are only three things that you need to do to have the wireless connection:

1. Set the WiFi security settings on the web conguration page.

2. Test if the WiFi settings are correct.

3. Unplug the Ethernet cable.

First, set the WiFi security settings on the web conguration page.

Make sure there is a WiFi router or AP on your home or oce network. Write down the WiFi security

parameters used in this WiFi AP/router, including the SSID , security mode, encryption protocols and the

“key” values. The supported WiFi security mode of the IP CAM is WEP(64 bits and 128 bits) and WPA-PSK(TKIP

and AES). In most of the home/oce WiFi environment, this is quite enough.

The easiest way to set the WiFi settings on the IP CAM is through KraunView software. Right-click the

searched IP CAM in the “Auto Search” list and click the “Web Congure” to open the login window of the IP

CAM. Fill in all the WiFi security parameters you have written down. The WiFi conguration is complete now.

Please refer to section 3.4 for more detailed description if needed.

Second, test if the WiFi settings are correct

You can now test if the above WiFi settings are correct. Click the “WiFi test” on the “WiFi Security” settings

web page. The testing result will be displayed in less than 60 seconds. If the test is failed, please check the

WiFi security parameters and test again.

Third, unplug the Ethernet cable

If the WiFi test is successful, you can then enable the WiFi connection by unplugging the Ethernet cable from

the IP CAM. The IP CAM will detect the Ethernet cable unplugged condition and start the WiFi connection.

After the WiFi is connected, the IP CAM will connect to the Internet immediately.

Notice :

1. Please remember that the WiFi connection will use a dierent IP address, you will need to do the “Auto

Search” function in the KraunView again to nd the IP CAM again after the WiFi is connected.

2. If you want to switch back to the wired Ethernet connection, just plug in the Ethernet cable into the IP

CAM again. Do not need to disable the WiFi function on the web pages.

Figure 2-9: Unplug the Ethernet cable to enable the WiFi function

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 36 37

Brak uwag

Kraun KW.04 Instrukcja Użytkownika Strona 9